17
Viewing Alarm Memory
After an alarm has been silenced and cleared from the display, you can
still review the points that were in alarm.
1. Ensure the system is turned off (On light is off). If there was an
alarm, and the system dialed your alarm company, the OK light
flashes. If you cancelled the alarm by turning the system off
before it dialed your alarm company, the OK light will not flash.
2. Press the [4] key. The following display shows that there are
alarms in memory:
3. Press and hold the [6] key to view those points which were in
alarm. This display shows that there was an alarm on point 4:
Flash = Alarm On = Cancelled Alarm
4. Reset the system or turn the system on again to clear alarm
memory.
To Next Page
Loading...
