28
Change Other Users’ Passcodes
I have this feature.
I do not have this feature.
This feature allows those with Owner type passcodes to change the
passcodes of system users.
1. Press key [6] to enter Show User Mode.
2. Enter your passcode. (Owner type required.)
3. Press [0].
The Part light begins flashing. You are now in Owner Passcode
Change Mode.
4. Enter the number of the passcode you want to change (1
through 8).
5. Enter a new passcode with the same number of digits as your
passcode.
The OK tone sounds.
If the error tone sounds, go to step 4. Try a different passcode.
6. Enter the new passcode again.
The OK tone sounds. Go to step 4 to change another passcode or
step 7 to continue.
If the error tone sounds, return to step 4. Be sure to enter the
same passcode in steps 5 and 6.
7. After changing a passcode you should check its user type.
Press [Clear] once to go back to Show User mode.
8. Press [Clear] a second time to exit the Passcode Change mode.
To Next Page
Loading...
