18
Resetting the System
Use this feature to reset the system (including fire points) after an alarm
and to clear alarm memory. Resetting the system takes about 20 seconds.
The All, Part, and point lights go out during reset. If points do not reset,
the OK light continues to blink. Call your alarm company for help.
1. Ensure your system is off (On light is off).
2. Press the [3] key and enter your passcode to begin the reset.
Resetting takes approximately 20 seconds. During reset, the
display shows the following:
3. After the system is reset, the display returns to normal operation.
To Next Page
Loading...
