Robert Bosch GmbH 1 689 989 330 | 2016-11-30
Operating DCU 220 | DCU 220 | 13 | en
Using the Touchpad
CAUTION: Do not use a sharp object such as a pen on the touchpad. Doing so may
damage the touchpad surface.
NOTE:
You can press Fn+F9 to toggle the touchpad on or off.
For optimal performance of the touchpad, keep your fingers and the pad clean and
dry. When tapping on the pad, tap lightly. Do not use excessive force.
The touchpad is a pointing device that allows you to communicate with DCU 220 by
controlling the location of the pointer on the screen and making selection with the buttons.
The touchpad consists of a rectangular pad (work surface) and a left and right buttons. To
use the touchpad, place your forefinger or thumb on the pad. The rectangular pad acts like
a miniature duplicate of your display. As you slide your fingertip across the pad, the pointer
(also called cursor) on the screen moves accordingly. When your finger reaches the edge
of the pad, simply relocate yourself by lifting the finger and placing it on the other side of the
pad.
To Next Page
Loading...
