Robert Bosch GmbH 1 689 989 330 | 2016-11-30
Operating DCU 220 | DCU 220 | 15 | en
Configuring the Touchpad
You may want to configure the touchpad to suit your needs. For example, if you are a
left-handed user, you can swap the two buttons so that you can use the right button as the
left button and vice versa. You can also change the size of the on-screen pointer, the speed
of the pointer, and so on.
To configure the touchpad, go to Settings Devices Mouse & touchpad
Navigation on the Touchscreen
The screen of DCU 220 is touch-sensitive. You can operate DCU 220 by touching the
screen with your finger or the stylus.
CAUTION: Do not use a sharp object such as a ballpoint pen or pencil on the touchscreen.
Doing so may damage the touchscreen surface.
NOTE: An optical film has been attached to the screen before shipment. The film is a
consumable, which will be worn out by possible scratches. You can purchase a new one
when replacement is required.
Using the Touchscreen
Your computer has a capacitive touchscreen. This type of touchscreen responds to objects
that have conductive properties, such as fingertips and a capacitive-tipped stylus.
You can change the touchscreen sensitivity settings to suit your scenario. Double-tap the Touch
Screen Mode shortcut on Windows desktop to open the settings menu and select one of the options
(as shown below).
1 Select this if you prefer using fingertips. Also, select this when raindrops are falling
on the screen and should be rejected as input
2 Select this if you are wearing gloves (referring to warm gloves or work gloves, not
referring to touchscreen-capable gloves).
3 Select this if you are using the stylus. (You must use the one supplied with your
model.)
To Next Page
Loading...
Need help?
General
