Bosch EPS 807 - Removing the Flange with Rotary Encoder; Removing the Rotary Encoder B1; Mounting the Rotary Encoder B1

1 689 975 140 2013-07-01| Robert Bosch GmbH
Repair works | EPS 807 / 815 | 21
en
6.6.5 Removing the flange with rotary encoder
1. Carefully loosen all clamping bolts (Fig. 35, Pos. 2)
counterclockwise by half a rotation.
2. Remove the hexagon socket head bolt (Fig. 35,
Pos. 3).
3. Carefully pull the flange with the rotary encoder
(Fig. 35, Pos. 1) from the shaft.
1
2
3
458741-21_Pal
Fig. 35: Removing the flange with rotary encoder
6.6.6 Removing the rotary encoder B1
1. Remove the hexagon socket head bolt (Fig. 36,
Pos. 1) for the cable clamp.
2. Remove the cable clamp (Fig. 36, Pos. 2).
! When pushing out the plug insert (Fig. 36, Pos. 3),
make sure the pins do not bend.
3. Carefully push the plug insert (Fig. 36, Pos. 3) of the
12-pole connector out of the plug housing using a
screwdriver (Fig. 36, Pos. 4).
1
2
3
4
458741-22_Pal
Fig. 36: Removing the plug insert
4. Remove the hexagon socket head bolt (Fig. 37,
Pos. 1).
5. Remove the rotary encoder B1 (Fig. 37, Pos. 2) from
the flange.
1
2
Fig. 37: Removing the rotary encoder B1
6.6.7 Mounting the rotary encoder B1
1. Place the new rotary encoder B1 in the flange.
2. Loosely screw in the hexagon socket head bolt
(Fig. 37, Pos. 1). Do not tighten!
3. Attach the connecting cable.