To Next PageTo Next Page
Need help?Do you have a question about the Bosch GCM 350-254 and is the answer not in the manual?
Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
Stay alert, use common sense, and avoid operating the tool when tired, under the influence of drugs, alcohol, or medication.
Specific warnings for mitre saws, including limitations on material types and use of abrasive cut-off wheels.
Explanation of symbols used in the manual to ensure safe and effective operation of the power tool.
Defines the tool's purpose for making straight cuts in wood and specifies its angular cutting capabilities.
The numbering of the components shown refers to the representation of the power tool on the graphic pages.
Details noise emission values and the importance of wearing hearing protection during operation.
Instructions for safe assembly, initial checks, and verifying all supplied parts are present.
Guidance on securely mounting the tool to a workbench or saw stand for stability and safety.
Health hazards from dust and the importance of using dust extraction systems during operation.
When mounting the saw blade, wear protective gloves. Danger of injury when touching the saw blade.
The transport safety-lock 9 enables easier handling of the machine when transporting to various working locations.
Essential checks before operating the tool, including RCD use for specific regions.
To ensure optimum working safety, the workpiece must always be firmly clamped.
Instructions for checking and adjusting the mitre angle settings for precise cuts.
Guidance on checking and adjusting bevel angles for accurate cuts, including standard and range adjustments.
Details on using pre-set stops for common mitre and bevel angles (0°, 47°, 45°, 33.9°, 22.5°).
Instructions for safely starting and stopping the power tool, including voltage checks and reduced starting current.
Fundamental advice for safe sawing, including securing knobs and levers to prevent blade jamming.
How to use the laser beams for precise workpiece positioning before cutting.
Do not stand in a line with the saw blade in front of the machine.
Specifies the maximum and minimum workpiece sizes that can be safely cut with the tool.
For cuts without slide movement (small workpieces), loosen the locking screw 6 if it is tightened.
For cuts using the slide device 36 (wide workpieces), loosen the locking screw 6 in case it is tightened.
Procedure for checking and calibrating the laser guide system for accurate cutting lines.
Instructions for safe maintenance and cleaning of the tool to ensure proper and safe operation.
List of accessories and their article numbers.
Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts.
General