Bosch GCM 8 SJ - Sawing Profile Strips;Mouldings; Ceiling Strips;Mouldings (US Standard)

English | 45
Bosch Power Tools 1 609 929 W28 | (16/4/10)
Ceiling Strips/Mouldings (According to US Standard)
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the
standard mitre angles of 31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
Settings Placed
against
the fence
Lying flat
on the saw
table
Vertical bevel angle 0° 33,9°
Ceiling strip/moulding
Left side Right side Left side Right side
Inner corner Horizontal mitre
angle
45° right 45° left 31.6° right 31.6° left
Positioning of
workpiece
Bottom edge
against the
fence
Bottom edge
against the
fence
Upper edge
against the
fence
Bottom edge
against the
fence
The finished
workpiece is lo-
cated...
... to the right
of the cut
... to the left of
the cut
... to the left of
the cut
... to the left of
the cut
Outer
corner
Horizontal mitre
angle
45° left 45° right 31.6° left 31.6° right
Positioning of
workpiece
Bottom edge
against the
fence
Bottom edge
against the
fence
Bottom edge
against the
fence
Upper edge
against the
fence
The finished
workpiece is lo-
cated...
... to the right
of the cut
... to the left of
the cut
... to the right
of the cut
... to the right
of the cut
52°
38°
52°
OBJ_BUCH-1168-001.book Page 45 Friday, April 16, 2010 5:25 PM