-17-
Position
combination
square.
3/4” (19mm)
board with
straight
top edge
Draw line.
No gap or overlap.
Flip square here.
Fig. 6
Tools Needed For Assembly
Verifying Parts
Check that you have the tools needed for the as-
sembly of the saw, as shown in Fig. 5.
Checking Combination Square
Check that the combination square is true.
1. Position the square and draw a light line as
shown in Fig. 6.
2. Flip the square as shown in Fig. 6.
3. Check the edge of the flipped square against
the drawn line, and make sure there is no
gap or overlap at the bottom end as shown
in Fig. 6.
Fig. 5
Combination Square
Torx Wrench (41)
(supplied)
16099221PJ GCM18V-10SD OSI 20220506.indd 17 5/6/22 11:42 AM
To Next Page
Loading...
