16
Unpacking And Checking Contents
Unpacking the Miter Saw – When removing this tool
from packaging materials, reach down to the two side
carry-handle locations and slowly lift until it clears the
package.
To avoid severe pinching,
never lift or move this saw by
gripping any component of the mechanism support
system.
This symbol is placed at various locations on
the tool to warn the user of pinch-point
areas.
Checking Contents in Package – Open the top of the
package and look for the included loose parts. Refer to
the diagram below.
Some small parts such as the bevel lock lever and miter
lock knob require attachment to the tool before it is
ready for use – See “Attaching Loose Parts” on page
18.
Workpiece Clamp
Manual
Miter Lock Knob
Loose Parts - 1 of each shown
Check off for each part
6/4mm Hex Key
2.5mm Hex Key
To Next Page
Loading...
