17
Tools Needed For Assembly
Combination Square
6/4mm Hex Key
(supplied)
#2 Phillips Screwdriver
NOTE: A 6mm and a 4mm hex key can be
substituted for the supplied 6/4mm hex key.
no gap or overlap
2. Flip square (shown in
dotted position)
3. Check edge of flipped
square against the drawn
line. There should be no gap
or overlap at the bottom
end.
drawn line
3/4" (19mm) board with
straight top edge
1. Position square and
draw a light line
Combination Square Must Be True -
Checking Combination Square
To Next Page
Loading...
