30
Adjusting Front Stabilizing Bolt
The front stabilizing bolt is located on the bottom of
the saw’s base near the 0° miter detent slot (Fig. 24).
It provides additional support when making slide cuts.
The stabilizing bolt has been factory set. If it is loose or
needs adjustment, follow these steps:
1. Move the saw so that you have easy access to the
bolt area. Loosen the stabilizing bolt and the jam nut
using a 10mm wrench.
2. Place the saw back on your work table. Unscrew the
stabilizing nut until it contacts the table.
3. Move the saw again so that you have access to the
bolt area. While holding the head of the bolt with
a 10mm wrench or pliers, use a 10mm open end
wrench to fully tighten the jam nut against the boss
in the saw’s base.
Bos
tabilizing
Bolt
Jam Nut
Fig. 24
Adjustments
To Next Page
Loading...
