48
Saw Operations
Bevel Range Selector Knob
Right Side of Table
1 2
3
1. Lift Bevel Lock (other side of table).
2. Tilt saw slightly to left. Move fence as needed.
4. Set saw to desired angle - Push down Bevel Lock.
3. Rotate Knob to desired range: Right or Max. 47°
(0-45° Left is automatic - no need to rotate knob).
BEVEL RANGE SELECTOR KNOB
Max. Bevel
Angle
to
47°
Left
or
Right
0-45° Left
0-45°
Right
Fig. 49
Bevel range selector knob – This saw has a front con-
trol on the right side of the table arm. This is called the
bevel range selector knob 41. It is linked to stops and
locking mechanisms in the rear which control the tool’s
ability to quickly and accurately be positioned to make
bevel cuts. There are positive stops at the important 45°
left, 0° (vertical), and 45° right angles (see Fig. 49).
USING THE BEVEL RANGE SELECTOR KNOB
Bevel Range 1 = 0-45° Left
This left-side bevel range is the default setting.
To operate in Bevel Range 1:
1. Move the left sliding fence out to clear saw assembly
and relock (Fig. 51).
2. Lift bevel lock lever above table height with left
hand.
3. Grasp the main handle with the right hand and tilt
the saw assembly to the angle desired.
4. Once in the desired bevel position, hold the saw
assembly with right hand and use left hand to fully
press down the bevel lock lever below table height.
NOTE: Without turning the saw “ON”, perform a dry cut
to make sure the fence clears the guards and adjust if
necessary.
To Next Page
Loading...
