56
Miter and Bevel Settings for Standard Crown Molding Cuts
(With Molding Flat on Table)
Assumptions: Molding is milled consistently. Corner is exactly 90°.
Molding Spring Angle 38° Molding Spring Angle 45°
Note: Always place top
edge against fence
Miter (Table)
Setting
Bevel (Tilt)
Setting
Miter (Table)
Setting
Bevel (Tilt)
Setting
Inside Corner -
Left end
Use the left end of the cut
31.6° Right 33.9° Left 35.3° Right 30° Left
Right end
Use the right end of the cut
31.6° Left 33.9° Right 35.3° Left 30° Right
Outside Corner -
Left end
Use the left end of the cut
31.6° Left 33.9° Right 35.3° Left 30° Right
Right end
Use the right end of the cut
31.6° Right 33.9° Left 35.3° Right 30° Left
Saw Operations
Top of Molding
Against Fence
Ceiling
45° Spring Angle
38° Spring Angle
52° 45°
38°
45°
45/45° Crown
Molding
38/52° Crown
Molding
Inside
Corner
Outside
Corner
To Next Page
Loading...
