–35º
Watch the numbers move in real time
in result line d as you move the laser
measure towards or away from the ob-
ject you are aiming at.
Press the measure button 2 [
] to
hold the measurement.
Press the measure button 2 [
] to re-
activate real time measuring.
Length Measurement
For length measurement, press the function button
7 [Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indicator
for length measurement and the word “Length”
appears in the status bar. Select length measurement
by pressing the measure button 2 [ ]. Activate the la-
ser by pressing the measure button 2 [ ]. The laser
will be switched on. Aim the laser at the object you
want to measure the distance to. Press the measure
button 2 [ ] again to take the measurement. The mea-
surement will be shown in the result line d.
⁄
4'02"
8'05"
⁄
12'07"
0.0º
Press the measure button 2 [ ] and
the previous measurement will move
to the bottom line of the measured-
value lines c.
Press the measure button 2 [
] for a
new measurement which will display
on the result line d.
Press the measure button 2 [
] and
the measurement from the bottom line
of the measured-value lines c will move to the middle
line of the measured-value lines c and the measure-
ment from the result line d will move to the bottom
line of the measured-value lines c.
Press the measure button 2 [
] for a new measure-
ment which will display on the result line d.
To Next Page
Loading...
