-26-
Working with the Tripod (Accessory)
The tripod is particularly useful for measuring great-
er distances. Position the laser measure with 1/4”
thread 13 onto the quick-change plate of a tripod 19.
Tighten the laser measure with the locking screw of
the quick-change plate.
Set the corresponding reference point for the mea-
surement with a tripod by pushing the measuring ref-
erence button 4 and using the plus button 3 [
] and
minus button 8 [ ] to scroll until the highlighted box
appears over the .
Error Message
If a measurement is not done correctly, the error mes-
sage “Error” appears in the display Turn the laser
measure off and on again, and start the measurement
again.
The symbol to the left will appear if there is a
defect with the laser measure. If this is the
case, have the laser measure checked by an
after sales service agent for Bosch power
tools.
To Next Page
Loading...
