-22-
The desired indirect height measurement X will dis-
play in the result line d. The measuring values for the
distances A and B and the angle C at which you took
the measurement will display in the measured-value
lines c.
c. Indirect Length measurement
(see figure D on page 5)
Press the function button 7 [Func] and use the plus
button 3 [
] or minus button 8 [ ] to cycle through
the measurement functions until the highlighted
square appears over the indicator for indirect mea-
surement and the word “Indirect” appears in the
status bar. Press the measure button 2 [ ]. Press
the plus button 3 [ ] or minus button 8 [ ] to cycle
through the indirect measurement functions until the
highlighted square appears over the indicator for in-
direct length and the words “Indirect Length” ap-
pear in the status bar. Press the measure button 2 [ ]
to select double indirect length measurement.
⅜
16'11"
60.0°
16'09" ⁄
0.0º
Press the measure button 2 [ ] to ac-
tivate the laser. Tilt the laser measure
while keeping the base of the laser
measure stable and point the laser on
a diagonal at the object you wish to
measure to. Press the measure button
2 [ ] to take the measurement A.
The desired indirect length measure-
ment X will display in the result line
d. The measuring values for the distances A and the
angle C at which you took the measurement will dis-
play in the measured-value lines c.
Memory Function
The last 20 measurements are automatically stored
(can be any type of measurement: length, area, vol-
ume, etc.). Memory can be accessed by pressing the
measure button 6 [ ]. Use the plus button 3 [ ] or
minus button 8 [ ] to scroll through the most recent
measurements.
To Next Page
Loading...
