-21-
highlighted square appears over the indicator for indi-
rect height
and the words “Indirect Height” ap-
pear in the status bar. Press the measure button 2 [ ]
to select indirect height measurement.
⅝
38'01"
45.0°
0.0º
Press the measure button 2 [ ] to ac-
tivate the laser. Tilt the laser measure
while keeping the base of the laser
measure stable and point the laser at
the height of the object you wish to
measure. Press the measure button
2 [ ] to take your measurement.
The desired indirect height measure-
ment X will display in the result line d.
The measuring values for the distance A and the angle
C at which you took the measurement will display in
the measured-value lines c.
b. Double indirect height measurement
(see figure C on page 5)
The laser measure can measure a vertical distance on
a surface, by taking two indirect measurements to that
surface.
Press the function button 7 [Func] and use the plus
button 3 [
] or minus button 8 [ ] to cycle through the
measurement functions until the highlighted square
appears over the indicator for indirect measurement
and the word “Indirect” appears in the status bar.
Press the measure button 2 [ ]. Press the plus but-
ton 3 [ ] or minus button 8 [ ] to cycle through the
indirect measurement functions until the highlighted
square appears over the indicator for double indirect
height and the words “Double Height” appear in
the status bar. Press the measure button 2 [ ] to se-
lect double indirect height measurement.
⁄
4'02"
8'05"
45.0°
0.0º
Press the measure button 2 [ ] to ac-
tivate the laser. Make sure the measur-
ing reference point remains stable.
Press the measure button 2 [ ] to
take the first measurement A. Press
the measure button 2 [ ] to take the
second measurement B.
To Next Page
Loading...
