Bosch Intellic EFAS-4.11 - Page 115

105
Workshop Manual
Smart Tachograph EFAS-4.10/4.11
N
National abbreviations 90
National regulations 2
Nominal voltage of the vehicle 34
O
Operating instructions 42
Operating states 18
Output Shaft Speed 35
Overview of Service IDs 55
P
Parameter conguration 33
Parameters for vehicle adaptation 33
PIN 21
Pin assignment 16
Pin assignment of the service port 11
Plug-in fuse 15
Preparations for installation 13
Printer paper container 10
Printer test 46
Printout of Service IDs 77
Printouts 97
Protocol, information interface 83
Protocol, k-line 83
Provisions for drivers and employers 4
R
Ranges of values 33
Receipt of device 13
Regional abbreviations 90
Regulation
(EC) No. 561/ 2006 2
(EEC) No. 3821/85 2
(EU) No. 165/2014 2
(EU) No. 1266/2009 2
(EU) No. 2016/799 2
(EU) No. 2018/502 2
regulations for tachographs 2
Removing a jammed smart-card 51
Removing the printer paper container 32
Removing the tachograph 51
Repair options 51
Repairs that cannot be carried out 52
rules when handling printouts 6
Rules when handling printouts 6
S
Serial interfaces D7 and D8 84
Service ID 44
Service port 11
Settings 31
Software update 90
Standards 2
Storage 14
Structure of a Diagnostic Trouble Code (DTC) 43
Symbols and what they mean 96
T
Tachograph smart-cards 5
Technical data 94
Terminating resistors 81
Test drive 41
Test equipment 40
Test functions 45
Testing for digital inputs/outputs 48
Testing the acoustic alarm 48
Testing the engine-speed signal source 48
Testing the internal battery 49
Testing the motion sensor interface 49
Testing the on-board power supply 48
Testing the pulse outputs 49
Testing the rotational speed 50
Testing the warning lamp 48
Time zone 32
Transmission interval of the TCO1 36
Trip distance 35
Type label 13
U
User warning messages 42
V
Viewing the data 6
Visual inspection 13
W
Warning light 9
Warranty 53
Working with menus 11
Workshop smart-card 5