To Next PageTo Next Page
Need help?Do you have a question about the Bosch SAIC VDI III and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | SAIC VDI III |
| Category | Measuring Instruments |
| Language | English |
Explains warning symbols, their structure, designation, and usage in the manual.
Describes warning signs observed on the product itself to ensure legibility.
Defines who is authorized to use the product, emphasizing trained and instructed personnel.
Details requirements and conditions for VDI III to comply with US FCC rules.
Provides information on the open-source software used in VDI III.
Outlines VDI III's compliance with EMC directive and potential interference.
Specifies that VDI III is intended for indoor use only and precautions.
Discusses responsibilities for VDI III users regarding wireless link directives.
Lists other documents related to VDI III, such as quick start guides.
Clarifies the proper application of VDI III and its accessories to avoid compromising protection.
Details the components included in the VDI III base kit and potential variations.
Illustrates and describes the buttons and standardized ports for operating VDI III.
Explains the fixed USB configuration and its role in configuration and updates.
Describes the requirements for WLAN connection setup using VCI Manager.
Covers various attributes like data transfer, power, and LED status.
Explains how the connection between VDI III and vehicle electronics is established.
Details how VDI III receives power from the vehicle battery or USB.
Explains the meaning of the different LED indicators on the VDI III front.
Describes the function of the VCI Manager Launcher program.
Details the VCI Manager program for configuring and updating VDI III.
Lists the system requirements for using the VCI Manager software.
Advises users to follow installation instructions for the user software.
Guides on downloading and installing VCI Manager and VCI Manager Launcher.
Explains the process of connecting the diagnostic device and preparing for firmware updates.
Steps to connect VDI III to a computer for initial setup and recovery mode.
Detailed procedure for installing or updating the VDI III firmware.
Steps to configure VDI III for network connection via VCI Manager.
How to ensure matching software versions between the computer and VDI III.
Instructions for setting up WLAN communication with VDI III.
Guides on configuring VDI III for connection via an access point.
Steps to configure VDI III for a direct point-to-point wireless connection.
Procedure to reset VDI III settings back to factory defaults.
Instructions for connecting VDI III to a vehicle's DLC interface.
Simple procedure to reset the VDI III device.
How to perform a loopback self-test of VDI III using the self-test adapter.
Addresses issues where the VDI III error LED is lit after power-up.
Provides steps to resolve issues when VDI III fails to power on.
Explains the cause of the red flashing vehicle LED and its resolution.
Describes the speaker beeping indication and its meaning related to power.
Discusses why VDI III might shut off immediately after disconnection.
Explains the flashing checkmark LED, often related to internal temperature.
Guides on how to test the diagnostic connection cable for defects using VCI Manager.
Troubleshooting steps for unsuccessful wireless communication with the DWA 131 E1 dongle.
Explains the meaning of the yellow icon and how to resolve it.
Steps to troubleshoot communication issues between the computer and VDI III via USB.
Troubleshooting for communication failures via WLAN or Ethernet.
Procedure to recover VDI III software if corrupted during updates.
Lists available spare parts and wearing parts for VDI III.
Instructions for temporarily shutting down the device.
Guidance on handling the device when changing its location.
Information on environmentally friendly disposal of VDI III and its accessories.
