Bosch MIC IP fusion 9000i - Scene Mode Scheduler; Pre-Positions and Tours; Pre-Position Mapping; Sectors

MIC IP fusion 9000i Camera | en 41
Bosch Security Systems User Manual 2017.11 | 0.20 | F.01U.349.011
North point
– Click the Set button to overwrite the existing North point. A dialog box appears with the
message, “Overwrite North point?” To confirm, click OK. To cancel, click Cancel.
– Click the Clear button to reset the North point to factory defaults. A dialog box appears
with the message, “Reset North point to factory defaults?” To confirm, click OK. To
cancel, click Cancel.
6.9 Scene Mode Scheduler
The scene mode scheduler is used to determine which scene mode should be used during the
day and which scene mode should be used during the night.
1. Select the mode you wish to use during the day from Marked range drop-down box.
2. Select the mode you wish to use during the night from Unmarked range drop-down box.
3. Use the two slider buttons to set the Time ranges.
6.10 Pre-positions and Tours
The camera can store up to 256 preset scenes. You can define the individual scenes that
comprise a Pre-position Tour.
You define individual pre-position scenes, then use these scenes to define the Pre-position
Tour. The tour starts from the lowest scene number in the tour and progresses sequentially to
the highest scene number in the tour. The tour displays each scene for a specified dwell time
before advancing to the next scene.
By default, all scenes are part of the Pre-position Tour unless removed.
To define a Pre-position Tour:
1. Create the individual pre-positions.
By default, all scenes in the list Pre-positions are in the Pre-position Tour.
2. To remove a pre-position from the tour, select the pre-position in the list and uncheck the
box Include in standard tour (marked with *).
3. Select a dwell time from the drop-down list Standard pre-position tour.
4. To start the Pre-position Tour:
Return to the Live page.
Click AUX Control.
Type 8 in the input box and click AUX on.
5. To stop the tour, type 8 and click AUX off.
6.11 Pre-position mapping
Preposition mapping allows you to map a function to a Show or Set action.
Action
Select the appropriate action: Show or Set.
Pre-position
Enter the number of the pre-position to map.
Function
Select the appropriate function from the drop-down list.
6.12 Sectors
Sector
The camera’s pan capability is divided into equal sectors (2, 4, 8, 16), as defined in PTZ
Settings > Number of sectors, for a total of 360°.