30 en | Installing a Camera Directly to an Indoor Wall AUTODOME IP 4000i
2017.08 | 1.0 | F.01U.xxx.xxx Installation Manual Bosch Security Systems
7. Connect the mating connectors from the user-supplied cables from the ceiling to the
matching connectors from the camera. Refer to the chapter Connection, page 39 for
more information.
8. Unlock the single safety locking screw on the base of the unit using the T10 Torx
screwdriver.
9. Attach the camera to the mounting plate by inserting the vertical tab on the plate into the
recessed slot on the top of the camera dome to the right of the safety locking screw.
10. Rotate the camera approximately 15 degrees in a clockwise direction to lock firmly into
place.
11. Secure the safety locking screw with the T10 Torx screwdriver.
To Next Page
Loading...
