26 en | Camera AUTODOME IP starlight 5100i IR
2023-01 | 1.2 |
User Manual
Bosch Security Systems
Longitude
Longitude is the east-west position of the camera in the spherical coordinate system WGS 84.
Ground level [m]
The elevation of the ground above sea level. To determine the elevation of the camera, add the
Ground level [m] value and the Height [m] value of the camera.
Azimuth [°]
The orientation of the camera in a counter-clockwise angle starting with 0° in the east (WGS
84) or on the X-axis (Cartesian). If the camera is directed towards the north (WGS 84) or the
Y-axis (Cartesian), the azimuth is 90°.
6.2 Scene Mode
A scene mode is a collection of image parameters that are set in the camera when that
particular mode is selected (installer menu settings are excluded). Several pre-defined modes
are available for typical scenarios. After a mode has been selected, additional changes can be
made through the user interface.
Current mode
Select the mode you wish to use from the drop-down menu.
Standard
This mode is optimized for most standard scenes both indoor and outdoor.
Sodium lighting
This mode covers most situations. It should be used in applications where the lighting changes
from day to night. It takes into account sun highlights and street (sodium vapor) lighting.
Vibrant
This mode provides a more vivid image with increased contrast, sharpness, and saturation.
LPR
This mode is optimized for capturing reflective number plates at high speed in combination
with IR-lighting. Short shutter speeds and low maximum gain providing sharp and high
contrast images of license plates.
Notes:
– During night-time, in monochrome mode only, the license plates will be clearly visible
while the rest of the scene will be dark.
– Depending on device positioning, car speed and used IR beam, customization of shutter
time and maximum gain is required.
– IR illumination is required.
Mode ID
The name of the selected mode is displayed.
Copy mode to
Select the mode from the drop-down menu to which you wish to copy the active mode.
Restore mode defaults
Click Restore Mode Defaults to restore the factory default scene modes. Confirm your
decision.
6.2.1 ALC
ALC mode
Select the mode for automatic light-level control:
– Fluorescent 50 Hz
– Fluorescent 60 Hz
To Next Page
Loading...
