Troubleshooting
Resolving problems
The following table is intended to help identify the causes of
malfunctions and correct them where possible.
Malfunction Possible causes Solution
Unit does not
operate.
Power failure. Check power supply.
Faulty cable
connections.
Check all cables,
plugs, contacts and
connections.
No connection
established, no
image
transmission.
Incorrect unit
configuration.
Check all
configuration
parameters (reset to
factory default if
necessary).
Faulty installation. Check all cables,
plugs, contacts and
connections.
Wrong IP address. Check the IP
addresses (ping).
Faulty data
transmission within
the LAN.
Check the data
transmission with
ping.
The maximum
number of
connections has
been reached.
Wait until there is a
free connection and
call the transmitter
again.
8
8.1
FLEXIDOME IP starlight
7000 VR
Troubleshooting | en 29
Bosch Security Systems 2016.06 | v1.0 | AM18-Q0710
To Next Page
Loading...
