Bosch OptiMUM Series - Specific Error Messages and Scale Issues

38
en Accessories
Display Possible cause Remedy
ERROR
SCALE
The scales do not
work properly.
■ Turn the rotary switch to y. Disconnect
the mains plug.
■ Try again after approx. 30 min.
Scales defective If the message appears continuously, the
scales may be defective. Please contact
the customer service.
ERROR
ARM OPEN
Swivel arm was
opened.
■ Turn the rotary switch to y.
■ Press the release button and push the
swivel arm down until it locks into place.
ERROR
BOWL MISSING
Bowl or bevel gear
(accessory) has
become loose.
■ Turn the rotary switch to y. Disconnect
the mains plug.
■ Tighten the bowl by turning until the
stop.
■ Tighten the bevel gear and close the
locking lever completely.
OVERLOAD
SCALE
or
UNDERLOAD
SCALE
The measurement
result is outside the
measurement and
display range of the
scales (-990 g to
5000 g)
■ Do not add more than 5000 g of
ingredients.
■ Do not remove more than 990 g of
ingredients.
OVERLOAD
or
UNDERLOAD
when using
SensorControl Plus
Too much or too little
of the ingredients was
added for the selected
programme.
■ Add ingredients according to the
specied quantities.
X “Using SensorControl Plus” see
page 31
Accessories
Accessories and spare parts can be purchased via trade stockists or customer service.
As the product range is being constantly extended, it is possible that there are additional
accessories which are not listed here. In this case, go to www.bosch-home.com to see
the latest accessories that are available.
Accessories Designation Description
MUZ9VL1 Continuous-feed shredder
For cutting, shredding and grating fruit,
vegetables and other foods.