Bosch PAM 220 - 9.4.3 3. MTR: Calculating the mitre angle; 9.4.4 4. BVL: Calculating the bevel angle; 9.4.5 Notes on Compound Mitre Operating Mode

English | 31
To measure the corner angle, place the fold-out and base legs flat against the
walls or set a known corner angle on the measuring tool.
Press the COM(7) button again to store the measured corner angle for the
compound mitre. CNR and the current angle will appear on the display.
3. MTR: Calculating the mitre angle
MTR
Press the COM(7) button again. MTR and the calculated mitre angle for the
mitre saw are indicated on the display. The mitre angle is used to define the
rotation of the saw table (MTR).
4. BVL: Calculating the bevel angle
BVL
Press the COM(7) button again. BVL and the calculated bevel angle for the
mitre saw are indicated on the display.
The bevel angle is used to define the incline of the saw table (BVL).
Notes on "Compound Mitre" Operating Mode
The calculated mitre angle MTR can only be transferred for mitre saws, for
which the setting for vertical cuts is 0°. When the setting for vertical cuts is
Bosch Power Tools 1 609 92A 56P | (12.07.2019)