Preventing material damage en
11
2.
Replace the nozzles using the appropriate wrench
and tighten them carefully to guarantee the seal.
Ensure that the nozzle does not become detached
during removal or fastening.
Removing the cover
1.
Remove the pan supports, burner caps, distributors
and rotary knobs.
2.
Undo the screws on the burners.
3.
Carefully remove the cover.
Reinstalling the appliance
▶
Install the appliance components in reverse order.
Checking if equipment is working
1.
Check that turning the rotary knob between the pos-
ition for maximum power and the position for min-
imum power does not cause the burner to go out or
result in backfire.
2.
If the gas flow from the burner is not correct:
‒ Check whether the nozzle is correct.
→"Injectors", Page10
‒ Tighten or loosen the bypass screw until the gas
flow from the burner is correct.
→"Adjusting the taps", Page10
Documenting the gas type conversion
▶
Attach the sticker showing the new gas type near to
the rating plate.
3 Preventing material damage
ATTENTION!
A build-up of heat may damage the appliance.
▶ Never cover the stainless steel gas cooktop, for ex-
ample with aluminium foil or oven protectors.
▶ Only use the accessories specified.
Heat can cause damage to adjacent appliances or kit-
chen units. If the appliance is in operation for an exten-
ded period, heat and moisture will be generated.
▶ Open a window or switch on an extractor hood lead-
ing to the outside.
A build-up of heat may damage the appliance.
▶ Do not use two burners or heat sources to heat one
single item of cookware.
▶ Do not use griddle plates, clay pots, etc. for a long
time at full power.
▶ Do not use large pots which can deflect flame onto
the cooktop.
▶ Do not remove the pan support and enclose the
burner with a wok stand as this will concentrate and
deflect heat onto the cooktop.
▶ Do not place anything, for example, flame tamer or
asbestos mat, between pan and pan support as ser-
ious damage to the appliance may result.
A build-up of heat may damage the controls.
▶ Do not use a large item of cookware on burners that
are close to the control knobs.
If a control knob is in the wrong position, this could
lead to malfunctions.
▶ Always turn the control knob to the "Off" position
when the appliance is not being used.
Handling the cookware roughly may damage the sur-
face of the appliance.
▶ Handle the cookware on the cooktop carefully.
To Next Page
Loading...
Need help?
General