en Installation instructions
6
An ingress of moisture can cause an electric
shock.
▶ Do not use steam- or high-pressure clean-
ers to clean the appliance.
The insulation on cables of electrical appli-
ances may melt if it touches hot parts of the
appliance.
▶ Never bring electrical appliance cables into
contact with hot parts of the appliance.
WARNING‒Risk of injury!
Faults or damage to the appliance and re-
pairs that have not been carried out correctly
are dangerous.
▶ Never switch on the appliance if there is a
fault with it.
▶ If the appliance is faulty, unplug the mains
plug or switch off the fuse in the fuse box.
Shut off the gas supply and call the after
sales service.
▶ Always have repairs carried out to the ap-
pliance and damaged gas lines replaced
by trained, specialist personnel.
Cookware that is not the right size, or that is
damaged or incorrectly positioned may cause
serious injuries.
▶ See the notes on cookware.
When switching on the burner, sparks are
generated in the ignition plugs.
▶ Never touch the ignition plugs while the
burner is being lit.
If a control knob is too stiff to turn or it is
loose, it must no longer be used.
▶ Contact our after-sales service immediately
to have the control knob repaired or re-
placed.
WARNING‒Risk of suffocation!
Children may put packaging material over
their heads or wrap themselves up in it and
suffocate.
▶ Keep packaging material away from chil-
dren.
▶ Do not let children play with packaging ma-
terial.
Children may breathe in or swallow small
parts, causing them to suffocate.
▶ Keep small parts away from children.
▶ Do not let children play with small parts.
2 Installation instructions
Observe this information when installing the appliance.
2.1 Statutory requirements
This installation must conform with the following:
¡ Manufacturer’s Installation instructions
¡ Local Gas Fitting Regulations
¡ Municipal Building Codes
¡ Refer to AS/NZS 5601.1 for Gas Installations
¡ S.A.A. Wiring Code
¡ Local Electrical Regulations
¡ Any other statutory regulations
2.2 Preparing to install
These built-in cooktops are intended to be inserted in a worktop cutout.
¡ Make a cut-out in the worktop with the required di-
mensions.
To Next Page
Loading...
Need help?
General