en Installation instructions
8
2.5 Positioning the appliance
Note:Do not use silicone to bond the appliance to the
worktop.
1.
Position the cooktop with the upper side facing
down on a flat, stable surface.
2.
Apply the adhesive seal supplied around the edge
of the recess on the worktop. The adhesive seal
prevents the penetration of liquids.
3.
Screw the brackets supplied into the specified posi-
tion so that they can turn freely.
4.
Turn the cooktop around and insert it into the re-
cess. Insert the cooktop in the right-hand side of the
recess.
5.
Turn the brackets and tighten them fully.
The position of the brackets depends on the work-
top thickness.
2.6 Electrical connection
Follow the instructions for electrical connection.
¡ An electrical 10amp socket needs to be within 1m
of the hotplate to allow electrical connection. The
socket must remain accessible after installation of
the appliance.
¡ This appliance is connected to the mains (240VAC)
by means of the connecting lead. The connecting
lead must be fixed to the kitchen unit to prevent it
from coming into contact with hot parts of the cook-
top or an oven installed underneath and remain ac-
cessible after installation of the cooktop.
¡ This appliance must be earthed. When connecting
the cooktop ensure that the earth wire is connected
first and that all wires are connected to the correct
terminals.
Wiring diagram
Observe the wiring diagram.