Ethernet Job Listing
9--7
1070 072 196-101 (00.06) GB
9.3 Error Messages
9.3.1 Client Error Messages
Error-free client commands are finished by:
D Command finished
Faulty commands are finished by:
D Command aborted Errorcode: 3363; Buffer overflow, amount of data too
large
D Rx IP-Rs BUEP-Error: Err1: 10, Err2: 00
Err1 corresponds to the error code in the error table.
Err1: 10 Err2: 0 = PST block address wrong
9.3.2 Server Error Messages
Error-free server commands display the received command only.
Errors that appear during the execution of the received command are output
with the message:
D BUEP: Err1: 10, Err2: 00
This error message is also sent to the client.
Err1 corresponds to the error code in the error table.
Err1: 10 Err2: 0 = PST block address wrong
9.3.3 ICMP Error Messages
The ICMP signals (Internet Control Message Protocol) are generated by
ICMP messages on the Ethernet.
Messages that are directly processed on the module:
D ECHO REPLY
D ECHO REQUEST
D REDIREKT
The other messages are indicated in the error output.
Errors that usually lead to a job abortion:
D DESTINATION UNREACHABLE
D TIME EXCEEDED
D PARAMETER PROBLEM
To Next Page
Loading...
Need help?
General
