Number Element Description
9 CONTROL IN/OUT port Control port with analog/logic inputs, high
power outputs and pins for DCF77 or slave
clocks.
10 CAN BUS port Port for connecting power amplifiers or routers.
11 ETHERNET port with status
indicator lights
Port for connecting to a PC or other network
devices.
12 Reset button Reset of the device: Briefly press this button to
reset the device.*
13 CONTROL IN port Control port with isolated or supervised inputs.
14 CONTROL OUT port Control port with open collector outputs.
15 AMP IN port Input for 100 V (or 70 V) audio signal from power
amplifier.
16 SPEAKER OUT port Output for speaker zones.
* If the reset button is pressed too long (e.g. > 4 seconds), the device enters the service
mode. Press the reset button again to exit the service mode.
12
en | System overview PAVIRO Controller
08-May-2017 | 04 | F01U306900 Operation manual
To Next Page
Loading...
