Bosch rexroth A15VO - Hydraulically Connecting the Axial Piston Unit

Installation 37/64
RE 92511-01-B/2019-10-09, A15V(L)O Series 11, Bosch Rexroth AG
Important for LRDRS. controllers! Port X is equipped with a protective plug (3).
This portmust be connected. Failure to do so could lead to malfunctions or
damage.
You will find other ports for the respective control in the datasheet92511.
Setting screws are protected against unauthorized adjustment by tamper-proof
caps. Removal of the tamper-proof caps will void the warranty. If you need to
change the settings, please contact your local contact person; you can find their
contact information at
www.boschrexroth.com/addresses
3. For versions with through drive, install the auxiliary pump according to the pump
manufacturer's instructions. The protective cover (5) is not pressure-resistant and
should not be used during operation.
If the axial piston unit is to be operated without through drive unit, it has
to be closed by means of a pressure-tight cover before the commissioning!
Forquestions regarding conversions, contact your proper BoschRexroth service
partner or the service department of the plant that manufactured the axial piston
unit; seechapter 10.5 "Spare parts" on page 53.
7.4.8 Hydraulically connecting the axial piston unit
WARNING
Excessive control pressure for controllers with external control!
The pressurization of a control valve to above the permissible maximum pressure at
portX, e.g.DG setting, causes an impermissible pressure increase!
▶ Make sure that the permissible external pilot pressure, e.g.viaa pressure relief
valve, is not exceeded (seealso datasheet92510 DG controller technical data).