Bosch rexroth CytroBox - Page 81

Commissioning 81/128
CytroBox, RE 51057-B/11.19, Bosch Rexroth AG
Setting the IP address using the operating unit
To set the IP address using the operating unit (see Fig. 1 on page24), proceed as
follows:
 Switch on the control voltage of the drive controller.
 Press the "Enter" key on the operating unit.
 Using the / keys, select "Ethernet" and confirm your selection with the "Enter"
key.
 Now use the / keys to select the interface which is connected and which you
would like to configure (e.g. X22).
 Now select the address which you would like to configure and/or check:
– IPaddress
– MAC address
– Gateway address
– Network mask (subnet mask)
The individual octets are accepted by pressing the "Enter" key. You can always get
back with the "ESC" key.