16/68 Installation
Bosch Rexroth Mellansel AB, Intallation and maintenance manual, Hägglunds VI, RE 15310-WA/10.2015
Series 44 and 64
Motor
Shaft
adapter
Rope drum
24 hole Ø22 mm (0.87 in)
24 hole Ø18 mm (0.71 in)
M20 alt.
3/4 UNC
M16 alt.
5/8 UNC
Fig. 9:
Tightening torque for assembly bolts, min. strength class 12.9* (ISO 898/1) :
Torque M16 = 340 Nm (250 lbf·ft)
Torque 5/8 UNC = 320 Nm (236 lbf·ft)
Torque M20 = 700 Nm (516 lbf·ft)
Torque 3/4 UNC = 600 Nm (443 lbf·ft)
* Class 12.9 is needed for max. allowed load on the motor. For less load, other bolts
can be used.
Series 84
M24
M20
Motor
Shaft
adapter
Rope drum
24 hole Ø28 mm (1.10 in)
24 hole Ø22 mm (0.87 in)
Fig. 10:
Tightening torque for assembly bolts, min. strength class 12.9* (ISO 898/1) :
Torque M20 = 700 Nm (516 lbf·ft)
Torque M24 = 1200 Nm (885 lbf·ft)
* Class 12.9 is needed for max. allowed load on the motor. For less load, other bolts
can be used.
To Next Page
Loading...
