Bosch Rexroth Hagglunds VI 64 Series - Motor - Valves

Installation 17/68
Hägglunds VI, RE 15310-WA/10.2015, Intallation and maintenance manual, Bosch Rexroth Mellansel AB
3.1.1 Motor – valves
Mounting of valve V 46-O on 44 – and 64-series motors
NOTICE
Before mounting of the valve, check that the motor is mounted into the bracket with
“D2” connection on the motor mounting surface facing downwards, see gure 12.
1
2
Motor
Cover
Valve
Fig. 11:
1: 4 pcs 5/8 UNC x 165 mm (6.5 in). Strength class 8.8 (ISO 898/1). Tightening
torque 200 Nm (150 lbf·ft)
2: 2 st. 5/8 UNC x 178 mm (7 in). Strength class 8.8 (ISO 898/1). Tightening torque
200 Nm (150 lbf·ft)
A
A
D
2
Motor mounting surface
2-speed plug
Fig. 12:
• Remove the cover on the motor mounting surface.
• Remove all plugs on the motor mounting surface.
• Mount the plug BSTP 3/4” (included in the mounting set) in the bottom of the hole
for port “A” see gure 12.
• Place the O-rings in the proper position on the valve mounting surface. Use grease
to keep the O-rings xed.
• Mount the valve against the motor with the ports in the corresponding position.