44/68 Installation
Bosch Rexroth Mellansel AB, Intallation and maintenance manual, Hägglunds VI, RE 15310-WA/10.2015
Screws (A)
Strength class
(ISO 898/1)
Tightening torque*
Nm lbf·ft
M24 10.9 960 710
1” UNC 10.9 1 100 810
*Lubricate with oil
Installation of brake assembly BA-85 single + double acting and
brake cylinder BCI-M
Notice! IMPORTANT!
Mounting direction with the locking of
toggle bearing against the washer and nut.
Fig. 51: Double-acting braking force direction
1. Grease the bushings (1) with Texaco Multifak EP2 or an equivalent grease without
solid additives and mount them on the bracket (910).
2. Grease the eccentric shaft – see paragraph 1. Mount the bushings (2) and
eccentric shafts (3 or 50 and 4 or 51).
3. Press bushings (5) into levers (6).
Notice! Make sure that the lubricating holes coincide. Insert the grease nipp le (7).
4. Mount levers (6) and mount keys (8). See g. 1, 2 or 3 for position of keys for
respective braking direction. Mount locking screws (9).
5. Mount lock rings (10) on the eccentric shafts. Insert the grease nipples 7.
6. Mount holding bolts (13), spring washers (15) and screws (16). Tightening
torque: 750 Nm (553 lbf·ft).
Notice! The spanner slots on holding bolt (13) must be mounted ush with the
brake cylinder centre line.
To Next Page
Loading...
