Bosch Rexroth Hagglunds VI 64 Series - Mounting of Winch on Foundation

Installation 27/68
Hägglunds VI, RE 15310-WA/10.2015, Intallation and maintenance manual, Bosch Rexroth Mellansel AB
Mounting of winch on foundation
Method No. 1
• A separate frame machined after welding to a parallel tolerance of:
• The frame can be welded or bolted onto the foundation.
Fig. 29:
Method No. 2
• Machine the surfaces of the frame parts against the brackets to a atness 0.5 mm
(0.020 in)
• Weld the frame parts on the foundation with a lining tool (if necessary, use the
winch as alignment tool).
• After welding take o the alignment tool and put 1-2 mm (0.04-0.08 in) thick layer
of Devcon B-compound between the brackets and the frame parts. Assemble the
winch without tightening the screws.
• Let the Devcon B-compound harden ac-cording to the Devcon B-specication.
• Tighten the screws, see tightening torque for respective bracket.
Fig. 30:
0,2 100