Bosch Rexroth Hagglunds VI 64 Series - Motor

To Next Page

To Previous Page

18/68 Installation

Bosch Rexroth Mellansel AB, Intallation and maintenance manual, Hägglunds VI, RE 15310-WA/10.2015

Mounting of valve V 46-C on 44- and 64-series motors

NOTICE

Before mounting of the valve, check that the motor is mounted into the bracket with

“D2” connection on the motor mounting surface facing upwards, see gure 14.

• Remove the cover on the motor mounting surface.

• Remove all plugs on the motor mounting surface.

• Mount the plug BSTP 3/4” (included in the mounting set) in the bottom of the hole

for port “A”, see gure 14.

• Place the O-rings in the proper position on the valve mounting surface. Use grease

to keep the O-rings xed.

• Mount the valve against the motor with the ports in corresponding position.

Motor

Cover

Valve

Fig. 13:

2-speed plug

Motor mounting surface

Fig. 14:

1.1.3 Motor – torque arm

Mounting of torque arm on series 44 and 64

• Remove the cover on the motor mounting surface

• Install the torque arm on cylinder block as shown in the gure.

In the installation, connection “D

” on the motor should be upwards.

Bosch Rexroth Hagglunds VI 64 Series - Motor - Torque Arm