1-12 Electric Drives
and Controls
Bosch Rexroth AG PSI 6500.xxx 1070087059 / 02
Safety Instructions
1.10 Working Safely
DANGER
If the start signal is present in the event of an error reset (acknowl-
edgement), the control immediately starts the program run! Haz-
ardous machine movements may be the result!
Therefore, before fault reset, you should make sure that there are
no persons in the danger zone of the welding equipment!
DANGER
During operation of the welding equipment welding splashes are
to be expected! They may cause eye injuries or burns. Therefore:
- wear protective goggles
- wear protective gloves
- wear flame-retardant clothes
DANGER
Danger of injury from sheet metal edges and danger of burns from
weld metal!
Therefore: - wear protective gloves
CAUTION
The strong magnetic fields occurring in the resistance welding
process may cause permanent damage to wrist watches, pocket
watches, or cards with magnetic stripes (e.g. EC cards).
Therefore, you should not carry any such items on you when wor-
king in the immediate vicinity of the welding equipment.
To Next Page
Loading...
