RE 30139-B/12.14 | VT-HNC100...X Bosch Rexroth AG 39/48
Commissioning
7.3.1 HNC - PC connection via serial interface
Establish the connection between the VT-HNC100...3X and your PC as follows:
Fig. 20: Connection and required accessories
7.3.2 HNC - PC connection via TCP/IP
For Ethernet-capable VT-HNCs, TCP/IP is optionally available as alternative for
the serial interface. Please observe the notes in the order code.
Make the VT-HNC100...3X ready for operation:
f Carefully check the wiring.
f Apply operating voltage to the VT-HNC100...3X.
Please observe the instructions for the installation program when installing
WIN-PED®.
f After having installed the program, you can start it by clicking on it.
Furthermore, the control type applicable for the HNC software must be installed.
To Next Page
Loading...
