RE 30139-B/12.14 | VT-HNC100...X Bosch Rexroth AG 5/48
About this document
1.3 Illustration of information
Consistent safety notes, symbols, terms and abbreviations are used so that you
can quickly and safely work with your product using this documentation. For a
better understanding, they are explained in the following sections.
1.3.1 Safety instructions
In this documentation, safety instructions are indicated whenever sequences of
operations are explained which bear the risk of injury or damage to property. The
measures described for preventing these hazards must be observed.
Safety instructions are set out as follows:
SIGNAL WORD
Type of risk
Consequences in case of non-compliance
f Precaution
• Warning signs: Draws attention to the hazard
• Signal word: Identifies the degree of hazard
• Type of risk: Specifies the type or source of the hazard
• Consequences: Describes the consequences of non-compliance
• Precautions: Specifies how the hazard can be prevented
Table 2: Risk classes according to ANSI Z535.6-2006
Warning sign, signal word Meaning
DANGER!
Indicates a dangerous situation which may cause death
or severe personal injuries if not avoided
WARNING
Indicates a dangerous situation which may cause death
or severe personal injuries if not avoided
CAUTION
Indicates a dangerous situation which may cause minor
or medium personal injuries if not avoided
NOTE
Damage to property: The product or the environment
could be damaged.
1.3.2 Symbols
The following symbols indicate notes which are not safety-relevant but increase
the understanding of the documentation.
Table 3: Meaning of the symbols
Symbol Meaning
If this information is not observed, the product cannot be used and/
or operated optimally.
f abc
Individual, self-dependent step
To Next Page
Loading...
Need help?
General
