4/48 Bosch Rexroth AG VT-HNC100...3X | RE 30139-B/12.14
About this document
1 About this document
1.1 Validity of the documentation
This documentation is applicable for the digital axis controls
VT-HNC100-...-3X/C..., VT-HNC100-...-3X/P..., VT-HNC100-...-3X/N... and
VT-HNC100-...-3X/E... of the VT-HNC100 product family of the 3X/... series. .
For the precise identification of the products see chapter 4.3 “Identification of the
product” on page 13.
This documentation is intended for assembly fitters, operators and service
technicians and plant operators.
This documentation contains important information on the safe and appropriate
assembly, transport, electrical connection, commissioning, operation, use,
maintenance, disassembly and simple troubleshooting of the product.
f You should read this documentation thoroughly, and in particular the chapter
“Safety instructions” before working with the product.
1.2 Additional documentation
Documentations marked with the book symbol must be available for you
before handling the product and must be complied with:
Table 1:
Title Document number Document type
Digital axis control
VT-HNC100...3X
RE 30139 Technical data sheet
Available on the
Internet under
www.
boschrexroth.
com
Declaration on the environmental
compatibility for EMC, climate and
mechanical load
RE 30139-U Environmental
statement
Available on the
Internet under
www.
boschrexroth.
com
Online help in the commissioning
software
WIN-PED® 6 and/or WIN-PED® 7
Available on the
Internet under
www.
boschrexroth.
com/hnc100
“First steps” towards WIN-PED Available on the
Internet under
www.
boschrexroth.
com/hnc100
General product information on
hydraulic products
RE 07008 Available on the
Internet under www.
boschrexroth.
com
To Next Page
Loading...
Need help?
General
