Need help?Do you have a question about the Bosch Rexroth IndraControl XM42 and is the answer not in the manual?
General| Type | Control Unit |
|---|---|
| Series | IndraControl XM |
| Operating System | VxWorks |
| Power Supply | 24 V DC |
| Protection Class | IP20 |
| Memory | 2 GB |
| Interfaces | Ethernet, USB |
| Operating Temperature | 0°C to +50°C |
| Processor | Intel Atom |
Explains the structure of safety instructions, including signal words and symbols.
Defines signal words (Danger, Warning, Caution) and the safety alert symbol.
Specifies voltage supply requirements and current consumption values for the control.
Provides essential notes and safety precautions for installation.
Details the procedure for mounting the control unit onto a mounting rail.
Details the connection and requirements for the external power supply unit.
Explains how to connect the 24 V voltage supply to the control via the XD1 plug.
Describes setups for 24 V voltage supply with and without electrical isolation.
Explains the importance and methods of grounding for noise immunity.
Emphasizes the need for an integral IT security concept for operation.
Outlines the step-by-step procedure for commissioning the device.
Guides on connecting the PC to the control using the USB interface for commissioning.
Introduces the LEDs and operating elements on the control for operation and diagnostics.
Details the initial firmware and its functions.
Guides on how to start and access the initial firmware functions.
Details the procedure for loading a backup from an SD card.
Explains how to update the initial firmware using a data carrier.
Describes the IndraControl First Touch commissioning application.
Explains how to manage firmware, including reboot and reset options.
Provides steps for fallback mode and recovery in case of errors.
To Next Page