Fig. 12-7: "Network configuration" dialog
The network settings are only applied after a control restart.
12.3.3 Firmware management
The "Firmware management" site of the IndraControl First Touch provides the
following information:
Fig. 12-8: "Firmware management" dialog
● Current control mode:
– "Initial Mode": The initial firmware is loaded or active (initial firmware ver-
sion is shown).
– "System Mode": Control was started with the previously installed system
firmware.
IndraControl XM42 Controls
47/65
Device description
R911345566_Edition 03 Bosch Rexroth AG
To Next Page
Loading...
