SD card Slot for SD card
●
Only the Rexroth SD card XA-SD02 (part no.
R911175017) is approved as memory medium for
the XG10 slot of XM42.
Plugging in and removing the SD card at runtime is
generally possible. However, it can cause a temporari-
ly increased runtime behavior and motion cycle time
exceedances or PLC and hardware watchdogs in case
of a high control load. Thus, plug in or remove the SD
card only in an uncritical machine state (e.g. home po-
sition)!
Weight 1.2 kg (incl. bus base)
Dimensions Refer to the housing dimensions (IndraControl XM42 operating in-
structions)
Tab. 7-1: Technical data
7.1 Voltage supply and current consumption
The following values apply to the operating voltage acc. to DIN EN 61131-2:
Nominal voltage at U
LS
24 V DC SELV/PELV
Maximum voltage range of the supply voltage al-
lowed U
LS
18 V DC to 31.2 V DC (incl. all tolerances and rip-
ple)
Current consumption of the control incl. the con-
nected S20 I/O modules from U
LS
at nominal volt-
age
Maximum 1.5 A
Current consumption of the control without the
connected S20 I/O modules from U
LS
at nominal
voltage
Typically 1.0 A
Power consumption of the control incl. the con-
nected S20 I/O modules from U
LS
at nominal volt-
age
36 W max.
Power consumption of the control without the con-
nected S20 I/O modules from U
LS
at nominal volt-
age
Typically 24 W
Reverse voltage protection of the supply voltage Diode
Fuse protection Internal protective fuse, 4.0 A
Transient protection
Pulse load up to 1,500 W
Present, suppressor diodes
10/65
Technical data
IndraControl XM42 Controls
Bosch Rexroth AG R911345566_Edition 03
To Next Page
Loading...
