Fig. 12-6: "Welcome" dialog
12.3.1 Hardware data
The "Hardware" site of the IndraControl First Touch lists all device-specific data
of the XM4x control in a table.
● Material index
● Hardware type plate
● Serial number
● Part number
12.3.2 Network settings
The "Network" site of the IndraControl First Touch is used to configure the net-
work settings during the initial commissioning. The currently configured network
settings are shown in the following three fields and can also be changed using
these fields:
● IP address
● Gateway
● Subnet mask
Enter a valid network setting and write that setting to the control (press the
Write configuration button). If writing the network settings is completed suc-
cessfully, a note is displayed in the header area of the site. The Reboot control
button is additionally displayed. It is used to restart the control and thus applies
the network setting.
46/65
Device description
IndraControl XM42 Controls
Bosch Rexroth AG R911345566_Edition 03
To Next Page
Loading...
