10.3 Mounting the control
Damages at the contacts by tilting the modules
Attach the modules vertically on the bus base and remove them vertically from
the bus base.
Fig. 10-5: Positioning and removing modules only vertically
Component destruction due to plug mounting
under voltage!
● Before mounting or demounting components, disconnect the control - includ-
ing its components - from voltage
● Connect the voltage only after the control and its components have been set
up
Possible damage to property due to improper
top-hat rail mounting
● Fasten the top-hat rail adequately.
● Connect the top-hat rail to a functional earth.
● Mount the control on the top-hat rail.
● Install the control in a control cabinet or an appropriate housing.
Mounting the control bus base
1. Correctly position the bus base as per the descriptions "Right Side" and
"Left Side".
IndraControl XM42 Controls
19/65
Mounting, demounting and electric installation
R911345566_Edition 03 Bosch Rexroth AG
To Next Page
Loading...
