12.1.4 Reset button
The "Reset" button is positioned on the higher located area of the control hous-
ing.
Fig. 12-5: Reset button
Press the "Reset" button at running control to trigger a voltage cycle (reset).
The "Reset" button is provided with two functions triggered when the reset but-
ton is pressed while applying the supply voltage:
● Press the "Reset" button < 5 seconds: Triggering the fallback mode (see chap-
ter 12.5 "Fallback and recovery" on page 56).
● Press the "Reset" button > 5 seconds until the LEDs DIA3 and DIA4 flash alter-
natingly: Triggering the initial firmware (see chapter 12.2 "XM4x initial firm-
ware" on page 40).
The "Reset" button can only be actuated with a sharp tool (e. g. pen-
cil).
12.2 XM4x initial firmware
The control variant "XM4x00.01" is delivered with initial firmware.
The initial firmware provides commissioning and maintenance functions. Basic
functions can me activated manually without any additional tools, see chapter
12.2.3 "Starting and opening the initial firmware" on page 42. The XM4x pro-
vides a simple interface with its operation mode switch SF1 and the LED display
panel.
The commissioning tool "IndraControl First Touch" (see chapter 12.3
"IndraControl First Touch" on page 45) provides a more comfortable operation
and more functions. If connected to a PC, it can be opened with a web browser.
The comprehensive mechanisms for commissioning with the IndraWorks Suite
are also supported by the XM4x control.
40/65
Device description
IndraControl XM42 Controls
Bosch Rexroth AG R911345566_Edition 03
To Next Page
Loading...
