● Installed system firmware version ("none" if no system firmware was instal-
led).
Press the buttons for the following actions:
● "Reboot into Initial Mode": Reboots the system and restarts the initial mode.
● "Reboot into System Mode": Boots an installed system firmware.
● "Archive SYSTEM|OEM|USER": Backs up the complete directory structure of
all partitions to a firmware archive (.fw file), also refer to chapter "Archive
SYSTEM|OEM|USER" on page 48.
● "Restore SYSTEM|OEM|USER": Restores a system installation from a backup
file, also refer to chapter "Restore SYSTEM|OEM|USER" on page 50.
● "Factory Reset": Restores the delivery state of the control. The complete di-
rectory structure is reset.
Caution: Loss of data!
An existing system firmware installation is deleted. The network set-
tings are reset to its delivery state.
Archive SYSTEM|OEM|USER
This function is used to archive the internal storage medium. This includes all
partitions and their file and directory structure as well as all remanent data. A
".fw" file is stored on the user partition of the control after the process. This file
can be loaded to a local PC at a later point in time (see chapter 12.3.4 "File
manager" on page 53).
The file name of a system archive can consist of 4-16 alphanumerical
characters and has to have the file extension ".fw".
The backup can only be started if the selected file name corre-
sponds to the archive rules. During as well as after the backup, a
corresponding message is displayed.
48/65
Device description
IndraControl XM42 Controls
Bosch Rexroth AG R911345566_Edition 03
To Next Page
Loading...
