Bosch SAIC GRADE-X - Page 3

SAIC GRADE-X
1
SAIC GRADE-X User Manual instructions
 Please read this user manual carefully before using SAIC GRADE-X.
 The current user manual is based on the current features and functions available. Any new added features and
functions will be added to the user manual in the future.
 When reading the manual, please pay special attention to the words “Note” and “Warn”. Read them carefully
for appropriate operation.
SAIC GRADE-X HARDWARE maintenance
 Avoid shaking or dismantling as it may damage the internal components.
 Do not use hard or sharp objects to touch it; do not use excessive force; do not expose the screen to strong
sunlight for a long period.
 Caution: keep it away from water, moisture, high temperature or very low temperature;
 Keep it away from strong magnetic fields.
Operation Instructions
 Keep the scanner away from heat or fumes when using it;
 If the vehicle battery contains acid
,
Please keep your hands and skin or fire sources away from the battery during
test
 Exhaust gas of vehicle contains harmful chemicals, please ensure adequate ventilation.
 Do not touch the cooling system components or exhaust manifolds when engine is running to high temperature;
 Make sure the car is securely parked and the selector is at P or N position to prevent the vehicle from moving
when engine starts;
 Make sure the diagnostic link connector is OK before starting the test; otherwise the scanner may be damaged.
BOSCH suggests you test the Power/Earth with multi-meter first.
 Do not switch off the power or unplug the connectors during testing, otherwise you may damage the ECU or
scanner;
Precautions
 Must be performed according to the above conditions.
 Using SAIC GRADE-X tester, away from heat and moving parts to avoid interference.
When energized electrical components, never disconnect the circuit to prevent the self-inductance, mutual
inductance computer and automotive sensors.
 When the electrical work, with non-magnetic objects close to the vehicle control unit with a vehicle control unit
may be damaged.
 When dismantling car control unit or electrical components shall be carried out at the ignition switch is turned
off after 10 minutes.